[ADDON] RoR State of Realm v1.2.4 UPDATED!

[Gangan]

[Gangan]

After playing around with it I've got some Questions.



Why does a yellow bar apear over the anchor Point?^^

And will the option to announce the status of BOs and Keeps in chat come back?
Could an option be added to show only the zone I'm in or some kind of filter to show only certain zones? (I don't mean t1/t4)

Thx, for providing such a usefull addon

[sullemunk]

The yellow bar on top of the SoR windows is the anchor bar and lets you manipulate the stack either throu rightclicks or layout editor, and is shown when hoovering anny of the SoR windows.
And yes, the announce will probably be implemented at some point. I only left it out because i wantet to release the core addon asap

[OldSerpenT]

Add-on throws a runtime error:


Register event handlers after creating windows to fix it:

line 60 and below.

[sullemunk]

Rather strange that one, since if you look at the top of the ss it creates the window

A /rel should fix it

[elk76]

I have an overlapping issue
the top zone covers the bottom zone.
I checked with or without T1 and T4 zones
the problem occurs when two or more zones are open

[OldSerpenT]

Rather strange that one, since if you look at the top of the ss it creates the window

A /rel should fix it

I switched it for myself. But one that you have uploaded has is backwards.

I have an overlapping issue
the top zone covers the bottom zone.
I checked with or without T1 and T4 zones
the problem occurs when two or more zones are open

As I can remember this has to do with screen fullscreen / windowed mode

[sullemunk]

Might just be a scale calculation error on my part.
There is a global scale and a window scale to do calculations with, and then there's screen resolution in the mix of it... Too much math for my chimp brain..

[sullemunk]

Add-on throws a runtime error:


Register event handlers after creating windows to fix it:

line 60 and below.

Ah, I see what you mean now. I usually reloads the ui a lot when coding and this happens on the initial startup, so it must have slipped by.

[elk76]

Might just be a scale calculation error on my part.
There is a global scale and a window scale to do calculations with, and then there's screen resolution in the mix of it... Too much math for my chimp brain..

I tested it in fullscreen and window mode but the problem persists (the old version worked properly)
any chance to fix it in the next release?